Websets

lesson 2

Click on layers > Merge > Visible if you have more than one layer.

Save your image as webset. It can be in any image format you like.

Click on File > Export > Image Slicer

In the Image slicer window, along the left side you will see a window that says FORMAT. Please be sure that the format there is JPEG. If it was a different format and you had to change it to JPEG, close the Image Slicer window and open it again. The format must be JPEG upon opening.

At the top left of your Image Slicer window, you will see five buttons that say TOOLS above them. One of the buttons (the one in the middle) looks like a knife. Click on the knife.

On the right side of your Image Slicer window, you will see your image displayed.

Remember where the top, middle and bottom sections are in your image.

Use your mouse to make a line that separates the top and the middle.

Make sure that NONE of the top is in the middle section

Use your mouse again to make a line the separates the middle and the bottom. Once you make your two lines, move your mouse very slowly over one of the lines. When the mouse is directly over the line, the mouse will change into a cursor with an arrow at both ends. When your mouse looks like that, you can grab the line and move it if you need to make any adjustments in the placement of the lines.

Go to the next lesson.